Zanussi ZOP37902 - Manual (Page 17)

3 Close the oven door
to the first opening posi-
tion (halfway). Then pull
forward and remove the
door from its seat.
4 Put the door on a soft
cloth on a stable surface.
5 Release the locking
system to remove the
glass panels.
90°
6 Turn the two fasteners
by 90° and remove them
from their seats.
2
1
7 Carefully lift (step 1)
and remove (step 2) the
glass panels one by one.
Start from the top panel.
Clean the glass panels with water and soap. Dry the glass
panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite se-
quence.
The middle panel has a decorative frame. The screen-
printing zone must face the inner side of the door. Make
sure that after the installation the surface of the glass pan-
el frame on the screen-printing zones is not rough when
you touch it.
Make sure that you install the top panel in the seats cor-
rectly. Refer to the illustration.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Solution
The oven does not heat up. The appliance is deactivated. Activate the appliance.
17
www.zanussi.com