Yamaha EM-203VCD - Manual (Page 56)

E-48
CAUSE
A nonstandardized disc is played back.
Disc is upside down.
Disc is dirty.
The input source selection is incorrect.
Disc is dirty.
Volume is set too high.
Setting of the TV MODE switch on the rear
panel is improper.
Batteries are dead.
Remote control transmitter is too far away
or is being used at incorrect angle.
Direct sunlight or lighting (of an inverter
type of fluorescent lamp etc.) is striking
the remote control sensor of the main unit.
Remote control transmitter is being used
near TV set with a remote control sensor.
SYMPTOM
A disc cannot be played back normally,
or there is a noise during playback.
Playback will not begin even if disc is
loaded.
No sound (or no picture).
Sound stops suddenly (always at the
same spot).
A picture is disturbed or unstable.
Remote control transmitter doesn’t
work.
TV functions strangely when the remote
control transmitter is used.
TROUBLESHOOTING
REMEDY
Play back another disc.
Load disc label side up.
Clean disc.
Select the Video CD player by pressing the VCD/CD
INPUT SELECTOR button.
Clean disc.
Lower volume.
Set the TV MODE switch to another proper position.
Replace batteries.
Use within 6 m and 60° radius.
Change position of the main unit.
Relocate this unit away from the TV or cover TV’s
remote control sensor.
VIDEO CD PLAYER
REMOTE CONTROL