Yamaha EM-203VCD - Manual (Page 40)

E-32
Automatic preset tuning
You can make use of an automatic preset tuning function.
With this function, this unit performs automatic tuning and
stores stations with strong signals sequentially. Up to 40
stations are stored automatically in the same way as in the
manual preset tuning method on the previous page.
1
Select the tuner by pressing the TUNER INPUT
SELECTOR button so that “TUNER” appears on the
display.
2
Press and hold the tuner MEMORY button for more than
2 seconds.
* The MEMORY and AUTO indicators flash.
This unit performs automatic tuning and searches FM and
AM stations in that order. Received stations are programmed
to A1, A2 ... A8 sequentially.
When the automatic preset tuning is completed;
The display shows the frequencies of the first preset station
(stored to A1).
Check the contents and the number of preset stations by
following the procedure of the section “To recall a preset
station” on the previous page.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on the previous page.
Notes
•
The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM
stations only.
• With this function, only stations with sufficient signal
strength are stored automatically. If the station you want
to program is weak in signal strength, tune in to it with the
Manual tuning method (in monaural) and program it by
following the procedure of the section “To store stations”
on the previous page.
• You can replace a preset station with another FM or AM
station manually by simply following the procedure of the
section “To store stations” on the previous page.
VIDEO CD CHANGER RECEIVER
VIDEO CD
Version 2.0 / Playback Control
PRESET/TUNING/BAND A/B/C/D/E
OPEN/CLOSE
DISC 1 DISC 2 DISC 3
DISC CHANGE
VOLUME INPUT SELECTOR
VCR•LD/TV•VCD/CD•TAPE/MD•TUNER
VCD/CD TUNER
MIC TONE MIC MIC MIXING
SOFT NORMAL MAX MIN
STANDBY/ON
PHONES
KARAOKE
PROGRAM
ECHO ECHO
MEMORY
MUSIC
DISPLAY MEMORY AUTO/MAN’L REPEAT TIME
TIME ADJ TIMER HOUR MIN
INPUT TRIM
TUNING OPERATION
STANDBY/ON
TIME
A
PROG
B C D
+ I0
E
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
PRESET
INPUT
TIME INDEX
INTRO DIGEST
KARAOKE SLEEP
VCD/CD
MUSIC
TUNER
PROGRAM
VOLUME
DISC SKIP RETURN PREV NEXT SELECT
STOP PLAY/PAUSE
LEVEL
ECHO/KEY
TEST
CENTER/REAR
/DELAY
RANDOM OPEN/CLOSE INDEX MODE
VCD/CD TUNER
2
1
1
Memory back-up
The memory back-up circuit prevents the programmed
data from being lost even if the AC supply lead is
disconnected from the AC outlet or the power is cut due
to temporary power failure. If, however, the power is cut
for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the
preset tuning steps.