Yamaha DSP-A2 - Manual (Page 69)

67
English
REMOTE CONTROLLER
Macro key
1st
(Turns on this unit.)
2nd
(Selects an input source.)
3rd
(Starts playback of a source.)
“ ” on area A of keys 1
“ ” on area A of keys 2
–
“ ” on area B of keys 1
“ ” on area B of keys 2
–
“ ” on area C of keys 1
“ ” on area C of keys 2
–
–
–
Function of the key (and area) carried out when a macro key is pressed
Macro key
1st
Turns on this unit.
Sets this unit to the standby
mode.
2nd
Carries out the function of the
TV key.
–
3rd
Carries out the function of the
VCR key.
–
Function of the key carried out when a macro key is pressed
The Macro feature allows you to operate several remote control functions in a programmed order by pressing one macro key.
(Also, refer to the table on page 62.)
Notes
• A key in which no function is stored will carry out no
command.
•
If it occurs that this unit will not receive the second command
because the internal operation of the first command takes a
long time, set the MACRO switch to the “SLOW” position.
•
Once you press a macro key, this unit will not receive the
command of another key (even if it is pressed) until this unit
finishes carrying out all commands of the macro key. Take
notice of this especially when the MACRO switch is in the
“SLOW” position.
• Once you press a macro key, you must keep the remote
controller directed at the main unit’s remote control sensor
until the remote controller finishes transmitting all command
signals of the macro key.
•
You can also use the OPERATION CONTROL keys while
using the macro functions.
TAPE/MD
CD
TUNER
VCR 1
VCR 2
DVD/LD
V-AUX
PHONO
EXT. DEC.
TV/DBS
TAPE/MD
CD
TUNER
VCR 1
VCR 2
DVD/LD
V-AUX
PHONO
EXT. DEC.
TV/DBS
SYSTEM
POWER ON
SYSTEM
POWER ON
STANDBY
SYSTEM
POWER ON
STANDBY
TV
VCR