Yamaha DSP-A2 - Manual (Page 36)

34
When you finish using this unit
Press the STANDBY/ON switch on the front panel or the
STANDBY key on the remote controller to enter the standby
mode.
To select the source connected to this unit’s
EXTERNAL DECODER INPUT terminals as
the input source.
Press the EXT. DECODER button. “EXT. DECODER IN” will
appear on the display.
Note
The input source selected in this way has priority over any
other input source already selected.
To select another input source, press the EXT. DECODER
button again so that “EXT. DECODER IN” goes off from the
display, and then use the INPUT SELECTOR.
Notes on input source selection
● Note that selecting an input source means that the source
which is connected to the corresponding input terminals on
the rear panel is selected.
* To select the source connected to the VIDEO AUX
terminals on the front panel, select “V-AUX”.
● The setting of the EXT. DECODER button cannot be
canceled by selecting another input source. To cancel it,
press the EXT. DECODER button again so that “EXT.
DECODER IN” goes off from the display.
● If you select a video input source without canceling the
setting of the EXT. DECODER button, you will see the
picture of the video input source and hear the sound of the
source selected by the EXT. DECODER button.
● If a different audio source is selected with the input selector
keys on the remote controller while enjoying a video source,
the sound from the newly selected audio source is heard,
but the picture from the video source can still be seen.
● When you select an input source, the DSP program (or the
state of no DSP program is used) which was used when the
same input source was last selected will be automatically
recalled.
● If a nonstandardized source is played back, or the unit
playing back a source is not operating correctly, “INPUT
DATA ERR” appears on the display.
Front panel
EXT. DECODER
STANDBY/ON
Front panel Remote control
STANDBY
or
Remote control
EXT. DEC.
or
BASIC OPERATION