Z Microsystems ZX Station - Manual (Page 7)

Document# 27-0007UM Issued 11/00 Rev. 1.0
TOOLS REQUIRED
PRECAUTIONS
Required Tools and Equipment
• Phillips screwdriver with about 10"
shaft.
• Adjustable wrench or box
wrenches
In preparation to install the ZX
Station, take the following precau-
tionary steps:
Verify the ZX Station power switch is
off. If the power is off, the light on the
front panel will not be illuminated.
DANGER: To avoid shock hazard:
• Do not connect or disconnect
the ZX Station during an
electrical storm.
• The power cord plug must be
connected to a properly wired
and grounded power outlet.
• Any equipment to which the ZX
Station will be attached must
also be connected to properly
wired and grounded power
outlets.
NOTE: For the fastest and easiest
installation of the ZX
Station, follow these steps
in the sequence they are
presented.
7
Starting Point