Zenoah EXZ2600DL - Manual (Page 24)

GB-24
EXZ2600DL
WARNING
• Always wear eye protection such as safety
goggles. Never lean over the rotating cutting head.
Rocks or other debris could be thrown into eyes
and face and cause serious personal injury.
• Keep the blade guard and the mad guard attached
in place at all times when the unit is operated.
• Before starting a job, check the area and remove
all obstacles and objects that could be thrown by
the blade.
• Do not adjust the wheel height or try to remove
anything entangled to the blade with the engine
running.
1. Before starting the engine, adjust the wheel height
for desired cutting depth (see page 15).
2. Before starting a job, plan your direction of travel so
that you can always hold the edger on you right side
and can walk on a hard surface as much as possible.
3. When starting to edge, run the engine at full throttle,
and slowly have the blade cut into the edge groove.
NOTE
• Do not use the HE-EX to make a new groove into the
ground. Such usage will not be covered by ZENOAH
Warranty.
8. Operation
(HE-EX only)
BLADE
ROTATION