Zenoah EXZ2600DL - Manual (Page 12)

GB-12
EXZ2600DL
ATTACHING THE PRUNING MECHANISM
(1)
(2)
(3)
(4)
(5)
(1) Main pipe (2) Gear case
(3) Screw hole (4) Fastening bolt
(5) Bolt
1. Remove the cap on the end of the main pipe.
2. Remove the screw screwed into the end of the gear
case.
3. Insert the end of the gear case into the main pipe.
4. Line up the hole on the end of the gear case into which
the screw is to be inserted with the hole on the main
pipe, and screw the screw firmly in.
5. Using a wrench, screw in the bolt provided to fix the
mechanism into place.
A standard package contains the items as shown be-
low.
(1) Guide bar (2) Saw chain
(3) Gase case (4) Sprocket
(5) Chain tension adjust screw (6) Nut
(7) Chain tensioner nut
(8) Chain cover
Install the guide bar and the saw chain on the gear case
as follows.
6. Set up
(PS-EX only)
WARNING
The saw chain has very sharp edges. Use protec-
tive gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around the
bar and sprocket.
WARNING
Pay attention to the correct direction of the saw
chain.
3. Fit the chain tensioner nut into the lower hole of the
guide bar, then install the chain cover, and fasten the
mounting nut to finger tightness.
(1) Hole
(2) Moving direction
(3) Chain tensioner nut