Yamaha AV-S70 - Manual (Page 31)

29
English
REMO
TE CONTR
OL
APPENDIX
PREP
ARA
TION
OPERA
TION
TROUBLESHOOTING
Be sure to investigate thoroughly before requesting repairs or after service. If it cannot be corrected, or if the problem is not
listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center.
Notes
• Sometimes the unit may cease to recognize operations due to a mistaken operation or as a result of strong external noise (such as irregular
voltage due to shock of impact, excessive static electricity, or lightning strike). If this happens, first disconnect the power cord, wait about
30 seconds, re-connect the power cord, and try the desired operation again.
• When requesting repairs or after service of the YAMAHA subwoofer and rear speakers NX-SW70 (sold separately), be sure to bring along
with this unit.
■ General
SYMPTOM CHECK Refer to page
■ When using a DSP program
SYMPTOM CHECK Refer to page
■ When using the remote control
SYMPTOM CHECK Refer to page
No sound output at all. • Is the AC power supply cord connected?
• Is the TV or VCR connected correctly?
• Is the input source selected correctly?
• Has this unit’s audio temporarily been lowered?
A “humming” noise is present. • Hum caused by external electromagnetic waves may be generated.
Try inverting the right-left polarity of the power cord and re-insert into
the AC outlet.
The STANDBY indicator
flashes slowly. • The unit is in Auto Power Off mode.
Turn off the main power if the unit is not to be used for an extended
period of time.
There is noise in the tuner or
TV and the video image is
unstable. • Is a tuner or TV that uses an indoor antenna located near the unit?
Use of an outdoor antenna is recommended.
Movie dialog and other audio
is difficult to hear. • Are you using one of the DSP programs CONCERT or SPORTS?
Select the other program.
The remote control does not
function properly. • Are the batteries used up?
• Is the remote control pointed at the sensor?
• Is the remote control too far from or too close to the sensor?
• Is direct sunlight or other intense light (such as an inverter fluorescent
lamp) striking the sensor?
• Is another remote control being used at the same time?
• Have the batteries been inserted in the correct direction?
Cannot control other
component. • Has the correct manufacturer code been set?
14
10 – 12
17
18
14
21
—
19, 20
3
3
3
3
3
2
23
• Has the remote control selector button “S70” been pressed? Press “S70”
when you want to control this unit after controlling another component.
• Has the remote control selector button corresponding to the component to
be controlled been pressed?
—
26, 27
0105AV-S70_23-30_EN 3/29/0, 4:04 PM 29