Yamaha AV-S70 - Manual (Page 17)

15
English
REMO
TE CONTR
OL
APPENDIX
PREP
ARA
TION
OPERA
TION
ADJUSTING THE SPEAKER OUTPUT LEVELS
When reproducing a Dolby Surround source using a DSP program such as DOLBY PRO LOGIC or DOLBY DIGITAL
ENHANCED, it is necessary to adjust each channel to the same output level in order to bring out the full digital effect of
these sound fields. Even when a different DSP program is used, it is possible to bring out the particular flavor of the sound
field in question.
Speaker output levels may be adjusted by using the remote control before playback by following the steps.
1
Press p to turn on the power.
If the STANDBY indicator is lit, turn on the power
using p on the remote control. If the main power is
off (when the STANDBY indicator is not lit), turn on
the power by pressing POWER on the front speaker
unit.
1
2
2
Press TEST.
Test tones (like pink noise) will be output in the
following order.
● When only the front speaker unit is being used
or the VIRTUAL SURROUND DSP program is
selected:
(Virtual) (Virtual)
● When an NX-SW70 is connected:
Front speaker unit
Rear speakers
RIGHT CENTER LEFT
RIGHT
SURROUND
LEFT
SURROUND
Front speaker unit
RIGHT LEFT
RIGHT
SURROUND
LEFT
SURROUND
0103AV-S70_09-16_EN 3/29/0, 1:00 PM 15