Zanussi ZWF 1840 W - Manual (Page 13)

13
Programme progress
• The programme progress display shows the pro-
gramme step that is currently being carried out.
• The multi-display shows the estimated time re-
maining (in hours and minutes) until the end of the
programme.
3
During the washing cycle the remaining time
may be increased or stay the same for a while
as the programme adjusts itself to different
conditions (e. g., type and quantity of laundry,
out of balance spin detection, special rinses,
etc.).
Interrupting a programme/
Adding washing
Interrupting a programme
• A washing programme can be interrupted at any
time by pressing the START/PAUSE button and
then re-started by pressing the START/PAUSE but-
ton again.
• To stop the washing machine before the pro-
gramme has ended, turn the programme knob to
OFF.
Important! Be careful if there is water in the appli-
ance!
Adding washing
1. First press the START/PAUSE button.
– If the door indicator is illuminated, the door cannot
be opened (because of high water level or high
temperature).
– When the door indicator goes out, the door can be
opened and it is possible to add washing.
2. Add washing and close the door again.
3. Press the START/PAUSE button again. The pro-
gramme continues.
End of the wash cycle/
Removing the washing
When the programme has finished, END will illumi-
nate on the programme progress display. As soon as
the door indicator goes out, the door can be opened.
1. Open the door and remove the washing.
2. Turn the programme knob to OFF.
3. Turn off the tap.
4. When you have finished washing, pull out the de-
tergent drawer a little to let it to dry out. Keep the
door very slightly open so that the washing ma-
chine can air.
If (NIGHT CYCLE) was selected:
Following a night cycle END will illuminate in the pro-
gramme progress display.
– To spin, turn the programme knob to OFF and then
to SPIN or DELICATE SPIN. Change the spin
speed, if necessary, and press the START/PAUSE
button (the washing is spun).