Yamaha DSP-AZ2 - Manual (Page 16)

14
SPEAKER SETUP
AC OUTLETS
VOLTAGE SELECTOR
SWITCHED 50W MAX. TOTAL
AC IN
MAIN
(SURROUND)
FRONT EFFECT
REAR IMPEDANCE SELECTOR
SET BEFORE POWER ON
L
L
L
L
+
+
+
+
REAR CENTER
A+B
REAR
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
16 ΩMIN./SPEAKER
CENTER
FRONT
MAIN A OR B
: : : :
:
:
MAIN A OR B
FRONT
6 ΩMIN./SPEAKER
4 ΩMIN./SPEAKER 6 ΩMIN./SPEAKER
6 ΩMIN./SPEAKER
4 ΩMIN./SPEAKER
REAR CENTER
CENTER
REAR :
: :
:
:
A + B 8 ΩMIN./SPEAKER :
A
B
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR CENTER
A+B
REAR
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
8 ΩMIN./SPEAKER
16 ΩMIN./SPEAKER
CENTER
FRONT
MAIN A OR B
:
:
:
:
:
:
MAIN A OR B
FRONT
6 ΩMIN./SPEAKER
4 ΩMIN./SPEAKER
6 ΩMIN./SPEAKER
6 ΩMIN./SPEAKER
4 ΩMIN./SPEAKER
REAR CENTER
CENTER
REAR
:
:
:
:
:
A + B 8 ΩMIN./SPEAKER :
Switch
position
Upper
Lower
Speaker
Rear
Center
Center
Front
Effect
Rear
Main
Rear
Center
Center
Front
Effect
Rear
Main
Impedance level
The impedance must be 6 Ω or higher.
The impedance must be 4 Ω or higher.
The impedance of each speaker must be 6 Ω or higher.
The impedance of each speaker must be 6
Ω or higher.
If you use one set of main speakers, the impedance of
each speaker must be 4
Ω or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 8
Ω or higher.
The impedance must be 8 Ω or higher.
The impedance must be 8 Ω or higher.
The impedance of each speaker must be 8 Ω or higher.
The impedance of each speaker must be 8 Ω or higher.
If you use one set of main speakers, the impedance of
each speaker must be 8
Ω or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 16
Ω or higher.
IMPEDANCE SELECTOR switch
■ IMPEDANCE SELECTOR switch
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise this unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the
standby mode.
Select the upper or lower position according to the impedance of the speakers in your system. Be sure to move this
switch only when this unit is in the standby mode.
(General and China models)
0103DSPAZ2_10-22_EN(GB) 02.8.22, 0:15 PM 14