Zanussi ZO 25 Y - Manual (Page 6)

6
INSTALLATION
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on “Door reversal directions” paragraph.
Positioning
This appliance is designed to operate in ambient
temperatures between 10
°
C (50
°
F) and 32
°
C (90
°
F).
It should be located in a dry atmosphere, out of direct
sunlight and away from extreme temperature e.g. not
next to a cooker or other sources of direct heat, or in a
very cold room e.g. an outhouse, where the
temperatures may fall below 10
°
C (50
°
F). If these
temperatures are exceeded i.e. colder or warmer, then
the appliance may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There must
also be at least 100 mm (4”) distance between the top
of the cabinet and any overhanging kitchen furniture.
There should also be a gap of 25 mm either side of the
appliance. Do not obstruct the space underneath. The
back of the cabinet may be placed close to the wall
but must not touch it. DO NOT install in places with
restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers or a spanner (see Fig. 1a).
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the
figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
Fig. 1
Fig. 1a
Fig. 2
A B
NP005
100 mm
10 mm 10 mm
D200
PR153
GB