Zebra Technologies R402 - Manual (Page 19)

Using the Optional Media Adapter Plates
If your media roll has a larger diameter
core, you can use an accessory (part
number 105810-002) to adapt the core to
the media holders.
1. Note which position will fit the
diameter of the roll core.
2. On the left side plate, align the pegs
with the screws and use a small
Phillips driver to tighten them.
3. On the right side plate, align the pegs
with the screws and use a small
Phillips driver to tighten them.
4. Align the plates so that the pegs hold
the roll core and press together.
5. Place the roll into the media
compartment.