Yamaha RX-V595RDS - Manual (Page 28)

28
TO RECORD A SOURCE TO TAPE OR MD
4 1 2
2
1,4
1
Select the source to be recorded.
Front panel Remote control
or
2
Play the source and then turn VOLUME up to confirm
the input source. (For detailed information on tuning,
see page 29.)
Front panel Remote control
or
3
Begin recording on the tape deck, MD recorder or VCR
connected to this unit.
4
When the tape deck or MD recorder is used for
recording, you can monitor the sounds being recorded
by pressing TAPE/MD MON / EXT. DECODER so that
the “TAPE/MD MON” indicator lights up on the display.
Front panel Remote control
or
Notes
• The settings of DSP and VOLUME, BASS, TREBLE and
BALANCE have no effect on the material being recorded.
• Composite video and S video signals pass independently
through this unit’s video circuits. Therefore, when recording
or dubbing video signals, if your video source unit is con-
nected to provide only an S video (or only a composite video)
signal, you can record only an S video (or only a composite
video) signal on your VCR.
• A source that is connected to this unit through digital termi-
nals only cannot be recorded by a tape deck or VCR con-
nected to this unit.
• Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of
copyright material may infringe copyright laws.
If you watch a video software that uses scrambled or
encoded signals to prevent it from being dubbed, there may
be a case that the picture itself will be affected by those
signals.
01RX-V595RDS-3 6/23/99, 1:12 PM 28