Yamaha RX-V595RDS User Manual

Page 14

CONNECTING TO DIGITAL (COAXIAL AND/OR OPTICAL) TERMINALS

If your DVD (LD) player, TV/DBS tuner, etc. are equipped with
coaxial or optical digital audio signal output terminals, they can
be connected to this unit’s COAXIAL and/or OPTICAL digital
signal input terminals.

To make a connection between optical digital audio signal
terminals, remove the cover from each terminal, and then
connect them by using a commercially available optical fiber
cable that conforms to EIAJ standards. Other cables might not
function correctly.

Even if you connect an audio/video unit to the COAXIAL (or
OPTICAL) terminal of this unit, you must keep the unit con-
nected with the same named analog audio signal terminals of
this unit, because digital signal cannot be recorded by a tape
deck or VCR connected to this unit. You can switch the
selection of input signals between “digital” and “analog” easily.
(See page 27 for details.)

Notes
• When connecting an audio/video unit to both of the digital

and analog terminals of this unit, make sure to connect to
both terminals of the same name.

• Be sure to attach the covers when the OPTICAL terminals

are not being used, in order to protect the terminals from
dust.

• The input signal from the DVD/LD input terminals is selected

in the following order of priority.
(input mode: AUTO position)
1 COAXIAL terminal
2 OPTICAL terminal
3 ANALOG terminal

• All digital audio signal input terminals are applicable to the

sampling frequency of 32 kHz, 44.1 kHz and 48 kHz.

DVD or LD player

TV/DBS tuner

(Europe model)

01RX-V595RDS-2

6/23/99, 1:11 PM