Zanussi ZT 6905 - Manual (Page 4)

4
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON/OFF push button
The ON/OFF indicator light comes on.
3. Check that there is rinse aid and
salt
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing programmes"
chart.
Close the detergent dispenser lid.
7. Set the programme
The selection of a programme occurs with the door
partially opened.
Press the programme push button which
corresponds to the washing programme you wish to
select, the corresponding indicator light will flash.
If necessary, press the HALF LOAD push button.
8. Start the programme
Close the door.
An audible signal advises you that the programme
has started.
The indicator light which corresponds to the
programme under way is now permanently on.
9. At the end of the washing
programme
At the end of the programme the dishwasher will
automatically stop and an audible signal informs you
that the programme has finished.
The "END OF CYCLE" indicator lights flashes.
The ON/OFF indicator light remains on until the
ON/OFF push button is depressed.
10. Switch off the dishwasher
Wait 15/20 minutes before opening the
dishwasher’s door; in this way you will avoid
burning yourself when removing the dishes and
avoid also the damage of the nearby furniture
caused by the escape of steam.
Switch off the dishwasher by pressing the ON/OFF
push button and open the door.
Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
onto the dishes in the lower one.
When the washing programme has finished, it
is recommended that the dishwasher is
unplugged and the water tap turned off.
In general it is not advisable to open the door
while the machine is working; if the door is
opened however, a safety device ensures that
the machine stops.
Important!
Care must be taken if the door is opened during
the hot phase or immediately after a
programme has finished, as steam may escape.
Operating sequence