Zanussi ZT 6905 - Manual (Page 20)

13
min 30 cm max 100 cm
max 100 cm + 2 m max
CS10
Ш 18 Ш 21
Water outlet hose connection
The end of the drain hose can be connected in the following
ways:
1. To the sink outlet spigot, securing it if necessary with a
clip.
2. Hooked over the edge of the sink using the special
curved plastic guide (if provided).
3. To a stand pipe provided with vent-hole, minimum
internal diameter 4 cm.
The waste connection must be at a height of between 30 cm
(minimum) and 100 cm (maximum) from the bottom of the
dishwasher.
The drain hose can face either to the right or left of the
dishwasher
Ensure the hose is not bent or squashed as this could
prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer than 2
metres and its internal diameter must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the couplings used for
connections to the waste outlet must be no smaller than the
diameter of the hose provided.
The sink plug must not be in place when the machine is
draining as this could cause the water to siphon back into
the machine.
Attention!
Our appliances are supplied with a with a
security device to protect against the return of
dirty water back into the machine.
If the spigot of your sink has a "no return valve"
incorporated this can prevent the correct
draining of your dishwasher.
We advise you therefore to remove it.
min 30 cm max 100 cm
min 4 cm
Ш 21
Ш 18
CS09
2 3 1
max 100 cm