ZyXEL Communications G-2000 Plus V2 - Manual (Page 10)

ZyXEL G-2000 Plus v2 Quick Start Guide
10
5 Run the connection wires through the gap in the support holder
6 Twist the support holder back to the vertical position and tighten the screw that connects the support
holder to the ZyXEL device.
5.2 Wall-mounted
Follow the steps to attach your ZyXEL device to a wall.
1 Locate a high position on the wall that is free of obstructions.
2 Connect two screws (not included) in the wall 80mm apart. You can use the diagram at the end of this
guide to help you mark the screw holes correctly. Use screws with 6mm ~ 8mm (0.24" ~ 0.31") wide heads.
Do not screw the screws all the way into the wall. Leave a small gap between the head of the screws and
the wall.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the weight of the
ZyXEL device with the connection cables.
3 Adjust the cables.