Yamaha DIO8 - Manual (Page 7)

7
Installing an optional I/O card
1. Turn off the power to the DIO8 and remove the power
cord from the DIO8.
2. Loosen two screws as shown below and remove the
slot cover.
Keep the cover in a safe place for future use.
3. Align the edge of the card with the guide rail inside the
slot as shown below and insert the card into the slot.
Push in the card until the connector on the card is
securely plugged into the terminal inside the DIO8.
4. Fix the card by tightening the two screws.
5. Connect the power cord to the DIO8 and turn the
power on.
■ Specifications
[AP8AD]+[AP8DA] cards used
[MY8-AD]+[MY4-AD]+
[MY4-DA] cards used
[MY8-TD]+[MY8-AT]+[MY8-AE] cards used
Total 0 cards Up to a total of 8 cards
Total 1 card Up to 6 cards Up to the number of vacant DIO8 slots
Total 2 cards Up to 4 cards Up to the number of vacant DIO8 slots
Total 3 cards Up to 2 cards Up to the number of vacant DIO8 slots
Total 4 card Up to 1 card Up to the number of vacant DIO8 slots
Total 5 or more cards cannot be used — —
Important!
Before installing an optional I/O card, be sure to turn off the power to the DIO8 and remove the power cord from the
DIO8. Otherwise, you may be in danger of electrical shock, and/or the unit or the card may be damaged.
A (1 –4 /1 –8 )
1
2
Caution:
Be sure to tighten the screws securely. Otherwise,
the card may not be appropriately grounded.
1
2
Guide rail
Sampling frequency (external sync) 39.69 kHz – 50.88 kHz
Power supply
USA and Canada : 120 V, 60 Hz
Others : 230 V, 50 Hz
Power consumption 70W
Dimensions (W
×
H
×
D) 480 mm
×
185.5 mm
×
411.6 mm
Weight 15.5 kg
Operating temperature 10 – 35˚C
Power cord length 1.5 m
Accessories Connection cable (68-pin, D-sub, half-pitch) x 2, Length: 3m