ZyXEL Communications 2602HW-C User Manual
Prestige 2602hw-c series, Prestige 2602hwl-c series, Quick start guide
Table of contents
Document Outline
- Prestige 2602HW-C Series
- 802.11g Wireless ADSL VoIP IAD Prestige 2602HWL-C Series
- Overview
- 1 Hardware Connections
- 1 DSL: Connect the Prestige to a telephone jack using the included telephone wire.
- 2 LAN: Use an Ethernet cable to connect a computer to a LAN port for initial configuration and/or Internet access.
- 3 PHONE: Connect one or more analog telephones to these ports using telephone wires. These are FXS (Foreign Exchange Station) ports.
- 4 POWER: Use the included power adaptor to connect this power socket to an appropriate power source (see the User’s Guide for power adaptors by region).
- 2 Initial Configuration
- 2.1 Zero Configuration
- 2.2 Web Configurator Access
- 2.3 Wizard Setup
- 1 In the Site Map screen, click Wizard Setup.
- 2 From the Mode drop-down list box, select Routing (default) if you want to use routing features such as NAT.
- 3 The next wizard screen varies depending on the Encapsulation you chose in the first wizard screen. From the Network Address Tr...
- 4 Fill in the fields with information from your voice service provider. Leave the default settings in fields for which no information was provided (except if otherwise specified).
- 5 Verify your LAN, WAN and SIP settings. To change the LAN settings, click Change LAN Configuration; otherwise click Save Settin...
- 6 Click Save Settings in the screen shown in step 4 to go to the final wizard screen.The Prestige automatically tests the connec...
- 2.4 Speed Dial Configuration
- 2.5 Lifeline Configuration (Prestige 2602HWL)
- 2.6 Make Calls Through the Internet
- 2.7 Wireless Configuration
- 2.8 NAT
- 2.9 Firewall
- 3 Troubleshooting
- 3.1 Set Up Your Computer’s IP Address
- 1 In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.
- 2 In Windows XP, click Network Connections. In Windows 2000/NT, click Network and Dial-up Connections.
- 3 Right-click Local Area Connection and then click Properties.
- 4 Select Internet Protocol (TCP/IP) (under the General tab in Win XP) and click Properties.
- 5 The Internet Protocol TCP/IP Properties screen opens (the General tab in Windows XP).
- 6 Select the Obtain an IP address automatically and Obtain DNS server address automatically options.
- 7 Click OK to close the Internet Protocol (TCP/IP) Properties window.
- 8 Click Close (OK in Windows 2000/NT) to close the Local Area Connection Properties window.
- 9 Close the Network Connections screen.
- 3.1 Set Up Your Computer’s IP Address
- 1 Hardware Connections
- Viewing Your Product’s Certifications