Zanussi ZUD 9124 - Manual (Page 17)

17
BUILDING-IN INSTRUCTIONS
Before carrying out any work, remove the plug from
the power socket.
Inner door reversal
1. Using a screwdriver release bracket (1) by pressing
on the internal spring (Fig.) and withdraw it from its
seat together with the door;
2. remove plug (2) and fit it in the hole left open on
the opposite side;
3. turn the door through 180°, remove the bracket (1)
and refit it on the opposite side.
4. Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the open
position until it is properly closed.
1
2
180
°
PR140
DO002/2
A
B
DO001
a
a
Grid preparation
Left door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure).
Right door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure).
To position the grid on the appliance proceed as fol-
lows:
Apply the grid to the base of the appliance by pushing
on to the clasps (a) until they click.