Technical specifications, Installation, Positioning – Zanussi ZUD 9124 User Manual
Page 15
15
TECHNICAL SPECIFICATIONS
Positioning
This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located on the inside left of the appliance.
The following table shows which ambient temperature
is correct for each climate classification.
SN
+10°C to +32°C
ST
+18°C to +38°C
The appliance should be located in a dry atmosphere,
out of direct sunlight and away from continuous heat
and extreme temperature, e.g. not next to a boiler or
radiator, or in a very cold room e.g. an outhouse. If
these temperatures are exceeded i.e. warmer or cold-
er, then the appliance may not operate correctly.
For building-in and door reversal instructions please
refer to the relevant instructions on the following
pages.
INSTALLATION
DIMENSIONS
Height
81,5
cm
Width
59,6
cm
Depth
54
cm
POWER SUPPLY VOLTAGE AND FREQUENCY
220-240 V / 50 Hz
TOTAL POWER ABSORBED
80 W
AVERAGE DAILY UNITS ELECTRICITY(*)
0,58 kWh
TOTAL GROSS CAPACITY
122 l
NET CAPACITY
Fridge
102 l
NET CAPACITY
compartment
17 l
STAR RATING
(*)This figure is based on standard test results in accordance with European Standard EN153. Actual con-
sumption will depend on how the appliance is used and where it is located.