Yamaha CC-75 - Manual (Page 35)

Tape A or tape B playback
1
Select the TAPE position with the INPUT SELECTOR
control, watching the display.
2
Open the DECK A or DECK B cassette compartment by
pressing the EJECT button.
3
Load the tape into the DECK A or DECK B cassette
compartment, and close the lid panel completely by
pressing the upper part of the center of the panel as
figured left.
* If you have loaded two tapes into both the DECK A and
B cassette compartments, select the DECK A or B in
which the tape you want to play back is loaded by
pressing the DECK A or B selector button.
4
Set the Dolby NR switch to B or C if the tape is recorded
with Dolby noise reduction, and to OFF if Dolby NR is not
used.
*
For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 29.
5
Set the reverse MODE switch as desired.
The reverse MODE switch can be operated before or during
playback, and changes tape playback as follows:
6
Press the play button to listen to side A, or the
play button for side B.
To stop playback
Press the stop button.
Note
When removing the tape, press the stop
button, and
then open the cassette compartment.
Direct operation
Even if an input source other than tape deck is selected,
pressing the play button (or the fast wind button) will start
playback (or fast winding) directly.
E-27
English
TAPE DECK OPERATION
3
DECK A selector button
DECK B selector button
Receiver
Tape Deck
2 5 6 6 4 2
1
1 2 3 4 5
CD
6 7 8
6 7 8 9 0
1 2 3 4 5
TIME PROG TAPE EDIT +10
A B C D E
REPEAT RANDOM STOP PLAY/PAUSE OPEN/CLOSE
MODE DISC SKIP TUNER
DECK A/B
PLAY STOP PLAY
TAPE
INPUT REC/PAUSE
- +
- +
EFFECT LEVEL SP/PHONES MODE DSS
POWER SLEEP DISPLAY VOLUME
1
6
6
DECK A/B
button
Side A only
Side B only
Side A → Side
B
Side B only
Side A
→
Side B
(Repeats 8 times)
Starts from side A.
Side A
→
Side B
(Repeats 8 times)
Starts from side B.
(Side A is not played
at the first time.)