Zanussi ZKT 650 D - Manual (Page 11)

11
Before using for the first time
Initial Cleaning
Wipe the ceramic glass surface with a damp cloth.
1
Important: Do not use any caustic, abrasive
cleaners! The surface could be damaged.
Operating the hob
Touch Control sensor field
To operate the Touch Control sensor field place your
finger from above flat onto the required field until the
appropriate displays come on or go out or the re-
quired function is carried out.
Switching on the Appliance
The entire appliance is switched on using the “On/
Off”
sensor field.
Touch the “On/Off” sensor field for approx.
2 seconds.
The digital displays will show _ and the decimal
point will flash.
3
Once the “On/Off” sensor field has been oper-
ated to switch on the appliance, one of the
cooking zones must be selected within ap-
prox. 10 seconds using the cooking zone se-
lection buttons. Otherwise the appliance
switches off again for safety reasons.
Switching Off the Appliance
To switch off the appliance completely activate the
“On/Off”
sensor field.
Touch the “On/Off” sensor field for approx. 1 sec-
ond.
3
When an individual cooking zone or the entire
hob is switched off, any residual heat is shown
with an
h (for “Hot”) in the digital display for
the appropriate cooking zones.