X-Micro Tech. WLAN 11g - Manual (Page 45)

Destination: Defines the destination of the incoming packet that the rule is applied to.
h interface (WAN or LAN) the rule is applied to.
●
IP Range Start: Type the start IP address that the rule is applied to.
e protocol (TCP, UDP, or ICMP) of the destination.
● Port
Range: Select the port range.
at the bottom of the screen.
Update: Click to update information for the rule if you have selected a list item and
have made changes.
Delete: Select a list item and click Delete to remove the item from the list.
New: Click New to erase all fields and enter new information.
Priority Up: Select a rule from the list and click Priority Up to increase the priority
of the rule.
Priority Down: Select a rule from the list and click Priority Down to decrease the
priority of the rule.
Update Priority: After increasing or decreasing the priority of a rule, click Update
Priority to save the changes.
● Interface: Select whic
●
IP Range End: Type the end IP address that the rule is applied to.
● Protocol: Select th
Add: Click to add the rule profile to the table
45