Yamaha RX-V870 - Manual (Page 9)

9
Connect the SPEAKERS terminals to your speakers with wire
of the proper gauge, cut to be as short as possible. If the
connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires is
correct, that is, + and – markings are observed. If these wires
are reversed, the sound will be unnatural and will lack bass.
Do not let the bare speaker wires touch each other and do
not let them touch the metal parts of this unit as this could
damage this unit and/or speakers.
● Use speakers with the specified impedance shown on the
rear of this unit.
How to Connect:
Red: positive (+)
Black: negative (–)
➀
Unscrew the knob.
➁
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
➂
Tighten the knob and
secure the wire.
* Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
Front speaker connection:
One or two speaker systems can be connected to this unit. If
you connect only one speaker system, connect it to either the
FRONT A or B terminals.
Rear speaker connection:
One rear speaker system can be connected to the REAR
terminals.
Center speaker connection:
One or two center speakers can be connected to this unit. If
you connect only one center speaker, connect it to either the
CENTER C or D terminals.
While connecting, be sure to set the CENTER speaker
impedance switch to the proper position.
Set to “C + D” when using two center speakers, or to “C OR D”
when using only one center speaker. If the switch is set to the
improper position, no sound may be heard from the center
speaker.
CONNECTING SPEAKERS
USING AUX TERMINALS (ON THE FRONT PANEL)
<
for RX-V1070 only
>
These terminals are used to connect an auxiliary video
input source such as a camcorder to this unit.
2
3
1
C D
C OR D
L
R
VIDEO
AUDIO OUT
AUDIO OUT
VIDEO OUT
Camcorder