Yamaha RX-V1900BL - Manual (Page 101)

97
En
Remote control features
AD
V
ANCED
OPERA
T
ION
English
You can clear all changes made in each function set, such
as learned functions, macros, renamed control area names
and setup remote control ID.
■ Clearing function sets
1
Press F
SETUP using a ballpoint pen or
similar object.
“SETUP” appears in the display window (4).
2
Press 8k / n repeatedly to select “CLEAR”
and then press 8
ENTER.
3
Press 8k / n repeatedly to select the desired
clear mode.
4
Press and hold 8
ENTER for about 3
seconds.
When the clearing is successful, “OK” appears in the
display window (4).
• “NG” appears in the display window (4) if clearing was
unsuccessful.
• “ERROR” appears in the display window (4) if you press a
button not indicated in the respective step, or if you press more
than one button simultaneously.
5
Press F
SETUP again to exit from the setup
mode.
■ Clearing a learned function
1
Press F
SETUP using a ballpoint pen or
similar object.
“SETUP” appears in the display window (4).
2
Press 8k / n repeatedly to select “ERASE”
and then press 8
ENTER.
3
Set the operation mode selector to
E
SOURCE and then press an input selector
button (3).
If you want to erase the function learned in the AMP
or TV control area, set the operation mode selector to
EAMP or ETV.
4
Press 8
ENTER.
“E-KEY” appears in the display window (4).
5
Press and hold the button you want to clear
for about 3 seconds.
If clearing is successful, “OK” appears in the display
window (4).
y
• If you continuously want to clear another function, repeat
step 3 through 5.
• Once you clear a learned function, the button reverts to the
factory setting (or to the manufacturer setting if you have
set remote control codes).
6
Press F
SETUP again to exit from the setup
mode.
• “NG” appears in the display window (4) on the remote control
if clearing was unsuccessful.
• “ERROR” appears in the display window (4) if you press
more than one button simultaneously.
Clearing configurations
Clear mode Descriptions
L:DVD (etc.) (L:Three-digit name of the selected control area)
Clears all learned functions the respective
control area. You can change the control area to
be cleared by pressing the desired input selector
button (3) or 5SELECT l / h repeatedly.
L:AMP Sets all learned functions for controlling the
amplifier functions to the initial factory settings.
Set the operation mode selector to EAMP to
select this clear mode.
L:TV Clears all learned functions for TV control area.
Set the operation mode selector to ETV to
select this clear mode.
L:ALL Clears all learned functions.
M:DVD (etc.) (M:Name of the selected macro button) Clears
the macro programmed for the selected macro
button (page 96). The assigned macro to the
selected macro button reverts to the initial
factory macro. Press the desired macro button if
you want to change the macro button you want to
clear the programmed functions of.
M:ALL Clears all programmed macros. The assigned
macro to the selected macro button reverts to the
initial factory macro.
RNAME Set all the name of the control areas to the
default settings.
FCTRY Set all settings of the remote control to the initial
factory settings.
Notes
Notes