Yamaha CD REWRITABLE DRIVE CRW8824S-NB - Manual (Page 34)

Installation
8 Connect the audio cable between the CRW8824S drive and the computer’s
sound card, or the motherboard’s audio connector if it has built-in audio.
One end of the audio cable has two connectors: a vertically-mounted type
(PH) and a horizontally-mounted type (MPC). Choose one that matches
your sound card’s connector. The connector at other end of the cable is
connected to “AUDIO OUT” of the CRW8824S drive. Make sure connector’s
lug is at the top.
AUDIO
OU T ID SELECT
PARITY
TERM
INATO
R BLOC
K SIZE
DC IN
PUT 1 +5V
G +12V
R
L 1 2 4
G
SCSI
INTE
RFAC
E CONN
ECTO
R
Vertically-mounted
type (PH)
Sound card
Horizontally-mounted
type (MPC)
Audio cable
Lug
You do not need to connect the audio cable to write audio CDs since the audio is
passed over the SCSI bus. It is required for playing back audio CDs on the
CRW8824S drive via the computer’s sound card. However, if a CD-ROM drive is
already connected to the sound card, you should use this drive to play back your
audio CDs. To listen to audio CDs without a computer sound card, connect
headphones or speakers to the headphone jack on the CRW8824S drive’s front
panel.
26