Yamaha YST-SW1500 - Manual (Page 11)

English
E-
7
Ⅵ Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
AC IN
ON POWER
OFF
HIGH LOW OFF
AUTO STANDBY
OUTPUT INPUT
REMOTE OUTPUT TO SPEAKERS
INPUT 1 FROM AMPLIFIER
100Hz 80Hz /MONO NORMAL
INPUT 2 INPUT 3
LFE
GND
H.P.F.OUTPUT
AC IN
ON POWER
OFF
HIGH LOW OFF
AUTO STANDBY
OUTPUT INPUT
REMOTE OUTPUT TO SPEAKERS
INPUT 1 FROM AMPLIFIER
100Hz 80Hz /MONO NORMAL
INPUT 2 INPUT 3
LFE
GND
H.P.F.OUTPUT
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz 80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz 80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
Left main speaker Right main speaker
Amplifier
Speaker output terminals
Caution
Do not let the bare speaker wires touch each other as
this could damage the subwoofer or the amplifier, or
both of them.
< U.S.A., Canada, Australia and Korean models only >
Banana Plug connections are also possible.
1Tighten the terminal knob.
2Simply insert the Banana Plug connector into the
terminal.
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker
cables are observed and set correctly. If these cables are
reversed, the sound will be unnatural and lack bass.
How to Connect:
Red: positive (+)
Black: negative (–)
1 Loosen the knob.
2 Insert the bare wire.
[Remove approx.
10 mm (3/8”)
insulation from the
speaker wires.]
3 Tighten the knob and
secure the wire.
1
2
3
1
2
Right
subwoofer Left
subwoofer
2-SW1500(UB) (02.9.2)a 02.9.2, 6:46 PM 7