Yamaha LPX-500 - Manual (Page 36)

Using the Menu Functions
32
Setup Auto Power
Off This sets whether the projector's power turns off automatically or not when
the signal from the input source that was selected using the [INPUT] button
stops being input.
Setting value range : Off, 30 min., 60 min.
•••• If a time is set, and if the connected source is equipped with a timer Off
function, the projector's power will be turned off once the set time has
elapsed after the input signal has switched off.
This can be used to ensure the projector turns off even if the viewer falls
asleep while viewing.
•••• When Auto Power Off has been activated so that the projector is in
standby mode, the power will not turn back on again even if an image
signal is input once more. Press the [STANDBY/ON] button on either the
projector's control panel or the remote control to turn the power back on.
Off
Trigger Out This is an output signal for controlling external equipment.
•••• While projection is in progress, a voltage of +12 V is output.
•••• When “Auto” is selected, the trigger out signal turns ON and OFF in
accordance with the illumination of the projector's lamp. When
“External” is selected, the trigger out signal turns ON and OFF in
accordance with control signals received via the RS-232C port.
Auto
Language Sets the display language for messages and menus.
•••• Press the on either the projector's control panel or the remote control,
and select the language from the selection menu that appears.
English
Reset All Resets all items in all menus to their default settings.
•••• Press the on either the projector's control panel or the remote control
to display the confirmation screen, and select “Yes”.
•••• To reset the "Image" menu settings to their default values, select "Reset"
from the sub-menu.
The "Lamp" and "Language" settings will not be reset.
-
Main menu Sub-menu Function
Default
setting