ZyXEL Communications Prestige 794M - Manual (Page 40)

Prestige 794M User’s Guide
Chapter 3 LAN 40
Figure 20 LAN: Ethernet
The following table describes the labels in this screen.
3.4 Ethernet Client Filter
Use the Ethernet Client Filter screen to set the Prestige to allow or block specified Ethernet
devices from accessing the LAN.
Click LAN and Ethernet Client Filter in the navigation panel to display the configuration
screen.
Table 13 LAN: Ethernet
LABEL DESCRIPTION
Primary IP Address
IP Address Type the IP address of your Prestige in dotted decimal notation. 192.168.1.1 is the
factory default.
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
Prestige automatically calculate the subnet mask based on the IP address that you
assign. Unless you are implementing subnetting, use the subnet mask computed
by the Prestige.
RIP The RIP field controls the format and the broadcasting method of the RIP packets
that the Prestige sends (it recognizes both formats when receiving).
Select RIP v1 if you are unsure what RIP version other Ethernet device(s)
supports. RIP v1 is universally supported.
Select RIP v2 to send detailed routing data.
Select RIP v2 Multicast to set the Prestige to send routing data in RIP-2 format
using multicasting.
Secondary IP Address
You can assign a different IP address (in the same subnet as the primary IP address) to the LAN
interface.
IP Address Type the secondary IP address of your Prestige in dotted decimal notation.
Note: Make sure this IP address is in the same subnet as the
primary IP address above.
Apply Click Apply to save your changes back to the Prestige.