Zanussi ZOB143 - Manual (Page 12)

Stainless steel or aluminium applian-
ces:
Clean the oven door with a wet sponge only.
Dry it with a soft cloth.
Do not use steel wool, acids or abrasive mate-
rials as they can damage the oven surface.
Clean the oven control panel with the same
precautions
Cleaning the door gasket
• Regularly do a check of the door gasket. The
door gasket is around the frame of the oven
cavity. Do not use the appliance if the door
gasket is damaged. Contact the Service
Centre.
• To clean the door gasket refer to the general
information about the cleaning.
Oven lamp
Warning! Be careful when you change
the oven lamp. Always switch off the
appliance before you start to replace the lamp.
There is a risk of electric shock.
Warning! Bulb lamps used in this
appliance are special lamps for use only in
household appliances. Do not use them to
illuminate household rooms or parts of rooms.
If you need to replace a lamp, the replacement
lamp must have the same power and be for
use only in household appliances.
Before you change the oven lamp:
• Deactivate the appliance.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
• Put a cloth on the bottom of the oven. This
prevents from damage to the oven light and
glass cover.
Replacing the oven lamp:
1. Find the lamp glass cover at the back of
the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with an applicable
300 °C heat-resistant oven lamp.
Use only the same oven lamp type as the
replacement lamp. It must have the same
power and be for use only in household
appliances.
4. Install the glass cover.
Cleaning the oven door
The oven door has two panels of glass. You
can remove the oven door and the internal
panel of glass to clean it.
The oven door can close if you try to re-
move the internal panel of glass before
you remove the oven door.
1
Open the door
fully and hold the two
door hinges.
2
Lift and turn the
levers on the two
hinges.
3
Close the oven
door to the first
opening position
(halfway). Then pull
forward and remove
the door from its
seat.
4
Put the door on a
soft cloth on a stable
surface.
12
www.zanussi.com