Zebra Technologies T300 - Manual (Page 22)

Zebra 6300 Printer User’s Guide
%
Adjusting the Printhead Position
A set screw is located on top of the Printhead Carrier Assembly that can be
adjusted to control print quality. This adjustment is set at the factory and will
probably not need further adjusting. However, with different types and thick-
nesses of media, some adjustment may be necessary. To adjust the printhead
position, refer to Figure 5. Turn the set screw until optimum print quality is
obtained. Some trial and error may be necessary.
Figure 4. Adjusting for Different Media Widths
Figure 5. Adjusting the Printhead Position
547000r1 Page 17 Tuesday, March 25, 1997 11:38 AM