Yamaha RL RX-E100 - Manual (Page 26)

E-24
ADD KX-E100 AND/OR MDX-E100 TO YOUR SYSTEM
There are six different combinations of components. Once
you choose a certain mode, recording starts and ends
automatically in a certain way for each mode.
Before recording
When you record by using MDX-E100 or KX-E100, you
must first make the connections as shown in “Connecting
the system” on page 5. For details, refer to the instructions
supplied with the MDX-E100 or KX-E100. A source from
the component which is connected to the
AUX terminal
component can be recorded on a tape or MD.
Dubbing setting
TAPE
MD REC
MODE START
TAPE REC
DUBBING
DUBBING
START
DUBBING
MODE
1
2
5
6
• Only the first track is recorded. After recording the
CD tray opens automatically.
• Same as CD (Tr1) = TAPE
• Same as CD = TAPE
• Recording automatically starts at the beginning of
the tape. (By pressing DUBBING START , the
tape automatically rewinds to the beginning if it is
in the middle.)
2
Press DUBBING START to start recording.
Note
• The displays 1~6 which include the component you have not
connected to your receiver (RX-E100) will be skipped.
1
Decide the combination of the components. Each
time you press
DUBBING MODE , the mode will
change in the below order.
• Recording automatically starts from the beginning
of the tape. (By pressing DUBBING START , the
tape automatically rewinds to the beginning if it is
in the middle.)
• When the recording on side A finishes while a
track is being played back, the recording on side B
starts from the beginning of the same track.
• The sound is automatically faded out when it gets
close to the end of side B.
3
4
Record unit Play unit
Record unit Play unit