Yamaha RL RX-E100 - Manual (Page 16)

E-14
USING THE BUILT-IN TIMER
Setting the clock
1
While the power is on, press DISPLAY to display
the time.
2
While holding TIME ADJ , press HOUR to set the
hour.
• If you want to move the time in the reverse direction,
press HOUR while holding TIME ADJ and PRESET/
BAND .
3
While holding TIME ADJ , press MIN to set the
minutes.
• If you want to move the time in the reverse direction,
press MIN while holding TIME ADJ and PRESET/
BAND .
To display the clock
Press DISPLAY .
The current time appears for about 8 seconds, then the
normal display returns.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
You must set the clock before you use the timer functions.
The clock is based on a 24-hour system.
Adjusting the brightness
of the display
You can adjust the brightness of the display. If you have
connected the CD player (CDX-E100), cassette deck
(KX-E100), and/or MD recorder (MDX-E100) to this
unit, the brightness of the displays is automatically
adjusted to that of this unit.
Press and hold DISPLAY for about two seconds so that
“Dimmer ±0” appears on the display. While holding
DISPLAY , turn INPUT clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to –6 (Preset value: ±0)
STANDBY/ON PHONES
DISPLAY
+ - + - R L
MEMORY AUTO/MAN'L
TIME ADJ TIMER HOUR PTY SELECT MIN
BASS TREBLE BALANCE
MAX MIN
VOLUME
INPUT
PRESET/TUNING PRESET/BAND
NATURAL SOUND STEREO RECEIVER RX-E100
HOUR DISPLAY
PRESET/BAND TIME ADJ
MIN
STANDBY/ON PHONES
DISPLAY
+ - + - R L
MEMORY AUTO/MAN'L
TIME ADJ TIMER HOUR PTY SELECT MIN
BASS TREBLE BALANCE
MAX MIN
VOLUME
INPUT
PRESET/TUNING PRESET/BAND
NATURAL SOUND STEREO RECEIVER RX-E100
INPUT
DISPLAY