Zebra Technologies 2722 - Manual (Page 4)

SHOCK HAZARD WARNING:
The printer and power supply should never be operated in a
location where either one can get wet. Personal injury could
result.
MEDIA WARNING:
Always use high quality Zebra approved labels, tags and
transfer ribbons. If adhesive backed labels are used that DO
NOT lay flat on the backing liner, the exposed edges may stick
to the label guides and rollers inside the printer, causing the
label to peel off from the liner and jam the printer. Eltron
approved supplies can be ordered from your Zebra dealer. For
the name of a dealer in your area, call the nearest Zebra office
(located on the back of this manual).
RELOADING HINT:
If you should run out of labels while printing, DONOT turn the
power switch OFF (0) while reloading or data loss may result.
The printer will automaticallyresume printing when a new label
roll is loaded.
iv
980260-001 Rev.A