Yamaha DSP-AX463 - Manual (Page 34)

PLAYBACK
32
En
1
Turn on the video monitor connected to this
unit.
2
Press E
SPEAKERS repeatedly to select the
front speakers you want to use.
The respective speaker indicators lights up in the
front panel display.
3
Press J
INPUT l / h repeatedly (or press
one of the input selector buttons (3)) to
select the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
4
Start playback on the selected component.
Refer to the operating instructions for the source
component.
5
Rotate D
VOLUME (or press
L
VOLUME +/–) to adjust the volume to the
desired output level.
6
Press G
PROGRAM l / h repeatedly (or
press 4
AMP and then APROG l / h
repeatedly) to select the desired sound field
program.
The name of the selected sound field program appears
in the front panel display.
See page 37 for details about sound field programs.
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the
input source (see page 33).
• When PCM signals with a sampling frequency higher than 48
kHz are input, this unit is automatically set to the “STRAIGHT”
mode (see page 38).
• To display information about the currently selected input source
in the OSD, see page 35 for details.
■ A quick guide to contents
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
Basic operations
USB
MULTI CH DVR V-AUX DTV/CBL DVD CD MD/CD-R TUNER
INPUT: DVD
Currently selected input
source
Available input sources
Notes
When you want to...
See
page
Enjoy high quality sound 40
Adjust the tonal quality of the front speakers 40
Adjust the parameters of sound field programs 39
Enjoy the sources with a wide dynamic range at night 41
Use headphones 34
Select a decoder to play back sources with 38
Automatically set this unit to the standby mode 36
Movie Dramatic
Currently selected
surround field program
01EN_DSP-AX463_B.book Page 32 Friday, February 1, 2008 2:09 PM