ZyXEL Communications Network Storage Appliance NSA-220 - Manual (Page 5)

ENGLISH
5
2 Connect the NSA-220
1 Use the included gray (Ethernet) cable to connect the
LAN port on the rear of the NSA-220 to a computer,
switch, or router on your network.
2 Connect one end of the power cord to the POWER
socket on the rear of the NSA-220 and the other end to the
external power supply. Connect the external power supply to
a power outlet.
1
Use ONLY the included power supply.
3 Press the power button on the front of the NSA-
220 to turn it on. Look at the front panel lights.
V
If no lights turn on, make sure the power
cord is not loose and that the power
source is turned on.
• The power button light turns steady blue.
• The SYS light turns steady green after a suc-
cessful startup (it takes about 50 seconds).
• The HDD lights come on if the NSA-220 detects
hard drives in the disk bays.
• The rear panel LAN port has a light that turns on
if the Ethernet port is properly connected to
your network. It blinks while sending or receiv-
ing traffic.
"
To turn off the NSA-220, press the power button in once only.