ZALMAN TNN 500AF - Manual (Page 33)

TNN 500AF
Peel off the Film from the Thermal Tape on the bottom of the RAM Heatsinks.
Stick the RAM Heatsinks onto the VGA RAM chips. Press the RAM Heatsinks firmly with
your finger for proper adhesion.
NOTE : 1) The bending strength of the Thermal Tapes reaches 90% after 24 hours of curing.
Do not put excessive force on the RAM heatsinks during this period.
2) Avoid getting grease or any kind of stain on the surface of the Thermal Tape.
The Thermal Tape may not stick. Clean the surface of the RAM with acetone or
alcohol before attaching.
1) If there are more than 8 VGA RAM chips on your VGA card, purchase additional RAM
Heatsinks (ZM-RHS1).
2) Thermal Tape loses adhesiveness after it has been used once. Thermal Tape cannot be
reused after it has been detached from a surface. If you need more, purchase it separately.