ZALMAN TNN 500AF - Manual (Page 25)

TNN 500AF
Determine the points that correspond to the location of the FETs and Northbridge chipset on
the back side of the motherboard.
Clean the surface of the point where the block will be attached.
Peel off the Film from the Thermal Pad on both ends of the block.
Firmly attach the blocks on the determined points.
NOTES : 1) To prevent short circuiting the motherboard, avoid soldered points, and any exposed
wiring or circuitry when installing the Rear-mount Thermal Blocks.
2) Thermal Pads lose adhesiveness after it has been used once. Try to attach it properly
on the first attempt.
3) Do not touch the Thermal Pad with your hands.