Yamaha RXV3000RDS User Manual
Page 53
English
51
Setting the Manufacturer Code in the Remote Control
You can control other components by setting a manufacturer code. A code can be set up in each component control area except for the OPTN
area. The Yamaha code is factory preset for DVD, CD-R, CD, MD, TUNER, and Å (LD code). There is no factory preset code on VCR1,
VCR2/DVR, V-AUX, PHONO, TAPE, CABLE, SAT.
1
1
Select the source component you want to preset by using the
input buttons.
2
2
Press and hold
LEARN
for about three seconds using a
ballpoint pen or similar object.
3
3
Use h/g to select the name of your component’s
manufacturer.
• You will find the names of most audio-video
manufacturers worldwide in alphabetical order on the
display window.
4
4
Press
POWER
(or any other button) on the remote control
while pointing it at the component to check if you have set
up the code correctly. If the component cannot be controlled
by the remote control, try entering another code for the same
manufacturer.
5
5
Press
LEARN
to confirm the preset.
• If you want to preset another code for another component
immediately, press
ENTER
and repeat steps 1 to 4.
Note:
• If you have already programmed a remote control function to a button, the function takes priority over the set up manufacturer code’s function.
■
Controlling a different component from the source component (input) you selected
1
1
Repeat steps 1 and 2 of the procedure in “Setting the
Manufacturer Code in the Remote Control”.
2
2
Select a Library (component category) by using q/w.
• There are 13 Libraries to set up a manufacturer code;
L:TV, L:CAB (CABLE), L:DBS, L:SAT, L:VCR,
L:DVD, L:LD, L:CD, L:MD, L:TAP (TAPE), L:TUN
(TUNER), L:CDR, *L:AMP.
* L:AMP has four codes; YPC, DSP, NO, and Zone2. “YPC”
should be selected to operate this unit. “DSP” is for operating
Yamaha DSP amplifiers other than this unit. “NO” is to clear
the main unit control area functions. Zone 2 function is not
equipped on this model.
3
3
Repeat steps 3 and 4 of the procedure in “Setting the
Manufacturer Code in the Remote Control”.
Note:
• “ERROR” appears in the display window in the following conditions: when pressing a button other than the cursor and
ENTER
; when pressing more
than one button at once; and when one of
MACRO ON/OFF
,
10KEY/DSP
,
PARAMETER/SET MENU
is switched to another position.
Remote Control Features
Flashes
alternately
LEARN