L/r balance, Hp tone ctrl (headphone tone control), Center geq (center graphic equalizer) – Yamaha RXV3000RDS User Manual
Page 44: Input rename, 3 l/r balance, 4 hp tone ctrl, 5 center geq, 6 input rename
Introduction
Preparations
Basic Operation
Advanced
Operation
Additional
Information
Appendix
42
SET MENU Items
3. L/R BALANCE
Use this feature to adjust the balance of the output level from the right and left main
speakers. Initial setting is the neutral position.
4. HP TONE CTRL (Headphone Tone Control)
Use this feature to adjust the level of bass and treble when you use your headphones.
The initial Setting is 0 dB for both bass and treble.
Select BASS or TRBL and press
+
or
–
to change each level. You can adjust
the level from –6 dB to +3 dB.
5. CENTER GEQ (Center Graphic Equalizer)
Use this feature to adjust the built-in five band graphic equalizer so the Center speaker
tone matches that of the left and right Main speakers. You can select the 100 Hz, 300
Hz, 1 kHz, 3 kHz, or 10 kHz frequencies.
1
1
Use g to select a higher frequency and h to select a lower frequency.
2
2
Press
+
or
–
to adjust the level of that frequency.
Note:
• You can monitor the Center speaker sound while adjusting this item using the
Dolby Surround test tone generator. Press
TEST
before starting the procedure
above. “TEST DOLBY SUR.” appears, and the test tone starts alternating among
the speakers. Once you begin the procedure above, the test tone remains at the
Center speaker and you can hear how the sound changes as you adjust the various
frequency levels. To turn off the test tone generator, press
TEST
repeatedly until
the current DSP program appears.
6. INPUT RENAME
Use this feature to change the name of the input which appears on the OSD or the
front panel display.
1
1
Select the input you want to change the name of by pressing an input button
(or using the
INPUT
selector).
2
2
Press
+
or
–
to blink the underbar for the space or character you want to edit.
3
3
Press h or g to select the character you want to use and
+
or
–
to move to the
next one.
• Press g to change the character in the following order, or press h to go in
the reverse order.
A~Z, a space, 0~9, a space, a~z, a space, #, *, +, and so on.
• Follow the procedure above to rename other inputs.
4
4
Press
+
or
–
repeatedly to exit the INPUT RENAME mode.
3
L
R
0
3 L/R BALANCE
L
R
0
4 HP TONE
BASS
0dB
4 HP TONE
TRBL
0dB
4 HP TONE CTRL
BASS
|
__________
TRBL
|
---------+
0dB
5 CENTER
100Hz
5 CENTER GEQ
≥ 100Hz
|
300Hz
|
1kHz
|
3kHz
|
10kHz
|
--------+
_________
VCR1 ->
VCR1
--------
6 INPUT RENAME
VCR1 ->
VCR1
--------