Zebra Technologies 2 - Manual (Page 25)

O-19 UMAN-EN2+
inside the media compartment that come in contact
with the linerless media adhesive should be cleaned,
along with:
• Ridged section on the latch
• Area around the Bar/Gap Sensor and Label Pres
ence Sensor
• Printhead
• Inside surface of the edge guide
Note: It is not necessary to clean the platen on
linerless units. The platen material is self cleaning
and will not require constant maintenance.
Never use any sharp objects on printer mechanism as it
could damage the print head and platen. Use only the
supplied cleaning pen or a cotton swab saturated with
alcohol for cleaning. Always turn the printer off prior to
any cleaning operation.
Allow printer to dry before resuming printing.