Yamaha mLAN Driver - Manual (Page 9)

9
“Select Source” dialog box
This dialog box enables you to
specify the mLAN device that
transmits mLAN data to the com-
puter.
1 Device List/Output Plugs
The Device List displays the
list of connected mLAN
devices. Select a device, and
the Output Plugs column will
show a list of mLAN plugs
included in the selected
device. When you select a
transmitting device and click
the [OK] button, the selected
device starts transmitting
mLAN data to the computer.
“Axx:” and “Mxx:” in the plug names mean “the xxth audio sequence” and
“the xxth MIDI sequence” respectively. The sequences are received in the
order shown in the Output Plugs list.
2 Disconnect
Click this button to cancel the device selection. Click [OK] under this condition to
disconnect all virtual transmission (mLAN connections) from the mLAN devices to
the computer.
3 Update
Click this button to initiate a system check and update of the condition of the con-
nected mLAN devices. Use this button if the settings on the mLAN devices are
changed after the mLAN Control Panel is started.
4 Revert
Click to reset the dialog box to its original status when first opened.
5 OK
Click to enable the dialog box settings and close the dialog box.
6 Cancel
Click to close the dialog box without applying the changes you have made.
The changes made to the dialog box become valid immediately when you
click the [OK] button in the lower right corner. You do not have to click the
[Set] button on the mLAN Control Panel. At this time, the Isochronous Ch.
parameter of the mLAN Control Panel is automatically assigned.
You can specify only one mLAN device as the source device.
A
B C D E F