ZyXEL Communications P-660R-T1/T3 V2 - Manual (Page 3)

P-660R-T1/T3 v2 Quick Start Guide
2
After you’ve made the connections, push in the power button
to turn on the P-660R-T1/T3 v2. Look at the LEDs.
• The POWER LED blinks while performing system testing. It
then turns steady on if the testing is successful.
• The DSL LED blinks then turns steady on, and blinks when
there is traffic.
• The ETHERNET LED turns on if the ETHERNET port is
properly connected, and blinks when there is traffic.
V
If none of the LEDs are on, unplug the device
and recheck your hardware connections.
2 Set Up Internet Access
You can configure the P-660R-T1/T3 v2 for Internet access in
any one of these ways:
A: Configuration Genie .
B: Zero Configuration .
C: Web Configurator Internet Access Wizard .