Zenoah PE2500H - Manual (Page 14)

■ STOPPING ENGINE
In case of emergency, immediately stop the
engine.
1. Return the throttle lever and run engine 1 to 2
minutes for cooling down.
2. Press the engine stop button(yellow) until the
engine completely stops. (F5)
■ AFTER USE
1. Release a drain plug at lower part of the pump
and drain the water out of the pump. (F6)
2. Disconnect the hoses, clean them for storage.
During cold climate, be sure to drain the pump after
every use. At an ambient temperature below
freezing point, the water in the pump casing may
freeze and damage the pump.
IMPORTANT
WARNING
7. Operation
❲ 14 ❳
F5
F6