Set up – Zenoah PE2500H User Manual

Page 11

• As a suction hose, be sure to use attached

suction hose(nominal diameter 25mm x 3m) or
an equivalent ‘water suction hose’ only.

• Securely connect hoses with attached hose

couplings and clumps.

• If the suction hose connection is loose, or a

packing in hose coupling has been lost or
damaged, air may be sucked into the pump and
interrupt water suction (air lock).

• A strainer shall be placed so that it does not

appear above water level nor suck bottom sand
and mud.

1. Place your pump at nearby water resource

horizontally.

2. Insert attached hose couplings to the suction

hose and discharge hose and tighten them with
clumps.

3. After checking the packing of each hose

coupling, connect the suction hose to a suction
port and the discharge hose to a discharge port.

Discharge port angle can be changed to 3 different
directions. Adjust to your operating condition.

4. Submerge the suction hose strainer in the water.
5. Lay the discharge hose where necessary.

Arrange protective covers if the hose can be
disturbed by foot steps of others.

6. Remove self-suction plug and top up the pump

with water. (F1)

7. Fill up fuel tank with fuel and tighten the tank cap

securely. (F2)

NOTE

IMPORTANT

6. Set up

❲

❳