Yamaha MC802 - Manual (Page 16)

SPECIFICATIONS
Total Harmonic
Distortion
Frequency Response
Less than 0.1%, 20Hz – 20kHz @ +14dB
into 600 ohms.
+1, –3dB, 20Hz – 20kHz @ +4dB into
600 ohms
Hum and Noise* (20Hz –128dB equivalent input noise.
– 20kHz, Rs=150 ohms, –90dB residual output noise (balanced
Input Gain max., Input outputs).
Pad @ 0dB, Input –73dB at STEREO OUT with master
Sensitivity –60dB) fader at nominal level and all
channel faders at minimum level.
–64dB at STEREO OUT with master
fader and one channel fader at
nominal level
–70dB at AUX SEND with AUX SEND
level control at nominal level
and all channel AUX controls at
minimum level.
–64dB at AUX SEND with AUX SEND
and, one AUX control at nominal
level,
Maximum Voltage Gain 84dB CH IN to STEREO OUT
84dB CH IN to AUX SEND 1
94dB CH IN to AUX SEND 2, 3
20dB AUX RETURN 1, 2 to STEREO OUT
10dB SUB IN to AUX SEND 1 – 3
10dB SUB IN to STEREO OUT
Phantom Power
+48 VDC applied to electronically balanced inputs via 6.8 k-ohm
limiting resistors. Master ON/OFF switch.
Power Requirements
U.S.&Canadian models: 120V AC, 60Hz
General model: 110 – 120/220 – 240V AC, 50/60Hz
Power Consumption MC1602: 60 watts
MC1202: 60 watts
MC802: 40watts
Dimensions (W x H x D)
MC1602: 730 mm x 151 mm x 531 mm
(28-3/4” x 6” x 20-7/8”)
MC1202: 590 mm x 151 mm x 531 mm
(23-1/4” x 6” x 20-7/8”)
MC802: 450mm x 151 mm x 531 mm
(17-3/4” x 6” x 20-7/8”)
Weight MC1602: 18 kg. (39.7 Ibs.)
MC1202: 15 kg. (33.1 Ibs.)
MC802: 12 kg. (26.4 Ibs.)
* Measured with a –6dB/octave LPF @ 12.7kHz.
• 0dB = 0.775Vr.m.s.
• Specifications subject to change without notice.
Input Channel Gain Control
–20
~
–60dB variation in gain, stop to stop.
Input Channel Pad Switch
0/20dB of attenuation.
Input Channel Equalization
15dB maximum boost or cut in each of three bands.
HIGH: 10kHz (shelving)
MID: 350Hz – 5kHz (peaking)
LOW: 100Hz (shelving)
Crosstalk –60dB at 1 kHz, adjacent input channels.
–60dB at 1 kHz, input to output.
VU Meters (0 VU = +4dB Output)
3 illuminated meters,
STEREO L, STEREO R, AUX1/AUX2/AUX3/CUE (switchable)
Clip Indicators
RED LED built into each input channel. Lights when post-EQ
channel signal is 3dB below clipping level.
14