beautypg.com

The control panel, 1 programme chart, 2 mains-on light – Zanussi TDE 4235 W User Manual

Page 6: 3 on-off button, 4 low temperature button, 5 buzzer off button, 6 start button, 7 “drying” light, 8 “cooling” light, 9 “end of programme” light

background image

6

1

2 3

4 5

6

11

7 9

8 10

The Control Panel

1 Programme Chart

This will help you to select the correct programme
for drying.

2 Mains-On Light

It comes on when the appliance is switched on (ON-
OFF button pressed down) and goes out when this
button is released.

3 ON-OFF Button

This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.

4 Low Temperature Button

Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.

5 Buzzer OFF Button

Press this button when selecting the programme if
you wish to switch the buzzer off during the anti-
creasing phase.
The corresponding light illuminates.

6 Start Button

Press this button for about 2 seconds to start the dryer
after having selected the drying programme.

If the door is opened while the programme is
running, this button must be pressed again after
closing the door in order to re-start the
programme from the point at which it was
interrupted.

This button must also be pressed after a power cut.
In both cases light

or

(depending on the

phase in progress) flashes to remind you that the start
button needs to be pressed again.

7 “Drying” Light

This light indicates that the machine is performing
the drying phase.

8 “Cooling” Light

This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light

or

is flashing, this means that the

Start Button needs to be pressed again for the
programme to resume.

9 “End of Programme” Light

This light flashes at the end of the cooling phase and
during the anti-creasing phase.

10 “Anti-creasing” Light

This light flashes alternately with the light

at the

end of the drying phase (after cooling) and during the
anti-creasing phase.

If only light

flashes, this means that the anti-

creasing phase has finished.

11 Programme/Time Selector Dial

It allows you to select electronically controlled or
time controlled drying.
Turn the dial to the required programme or time.

125981440.qxp 6/1/2005 11:18 AM Page 6